Sony application install guide
Requirements:
- Sony Bravia Pro Display with Android TV 10 operating system
- USB flash drive
- WbDeviceService downloaded from:https://apps.wallboard.info/sony/latest/WbDeviceService.pkg
Installation steps:
- Perform a Factory reset on the Sony display. (Settings -> System -> About -> Reset -> Factory Data Reset).
- After the Factory reset is complete do NOT start the initial setup!.
- Connect a flash drive to the Sony display with the WbDeviceService.pkg in the root directory.
- Allow access for the NodeRuntimeNormal and the NodeRuntimePrivilege to the media files.
- The display will recognize the application on the flash drive and will start the installation.
- After the installation has been completed the display will ask for permission to set the application up as a device owner, accept it.
- Finish the Android initial setup process.
- Press the Display + Mute + Vol Up + Home buttons to start the Pro mode setup process.
- When the display finished the transition to Pro Settings mode, start the DeviceService application, type in the server URL to which you want your device to connect.
- Go to Settings -> Pro Mode Settings, and find the Initial Source option, set up the Device Service application as the initial source.
- Find the Apps section in the Pro Mode settings, and enable the signage application.
- Go to Settings -> System -> Power and energy, and set the Power saving, and the Idle TV power off.
- (Optional) Go to Settings -> System -> Date and time, and set the time zone.
Note: Before Starting Pro mode make sure that you finished setting every Setting in the Android Settings because once Pro mode is enabled you cannot access the Settings application. - Go to the top and press the Start Pro mode option.
- The display will restart, and will start the Device Service application automatically (It might take some time for the display to start the application).